The following is an outline of technologies that can remove water from oil, together with their relative advantages and disadvantages. The most critical issue is how to remove the water from your vehicle's gas tank so that your vehicle will run well again. T. Joined: May 2007. Water seems to have gotten into the oil of my wife’s '98 VW Jetta.It apparently got in through the broken dipstick tube (thank’s Jiffylube).The result is a light colored pasty mess on the inside of the valve cover and most likely everywhere else.What is the best way to clean this sludge from the engine? That water probably came into the oil through a blown head gasket.
Before gasoline was adulterated with alcohol, a small amount of water could be dealt with by adding a co-solvent or an emulsifier. and the required flow and processing rate. Keeping water-absorbent socks in your oil tank ensures that water doesn't have an opportunity to settle at the bottom of your tank, which protects your tank from water-related damage. While these additives work to separate the two substances, they do nothing to get the water out of the tank, … Best oil additive for older engines have long been used to increase the performance and efficiency of motor vehicles.
When contained together, water settles to the bottom while oil rests on top. #2355551 08/23/11 06:09 PM: Joined: May 2007. Common water-separating additives fail to eliminate moisture from fuel reserves, simply enhancing the polarizing physical makeups of fuel and water. etc.) If a engine ever gets water in it's oil (Milky color I know) what is the best way to remove it? Fresno, CA. Gravity Separation. Modify Your Tank's Temperature: Since condensation is caused by temperature differences between the interior of a tank and the outside air, you can take some steps to reduce this issue. Products like Gasline Antifreeze would do the job. Drain the engine the same way as you would when doing an oil change, remove the drain plug in the oil pan.
I know you can do multiple oil changes, but I've also heard that you can drain all the oil and then flush it w/ Diesel Fuel to get any remaining water. Tantalus. It's difficult to determine how water gets into a vehicle's gas tank, but once it's there explanations are almost irrelevant. T. Tantalus OP: OP. This used to be simple. When it comes to using oil additives in older or high mileage engines, it is important to choose a quality product with proven results. While it is important to remove the water, determine where the water entered the system and repair it using a root-cause maintenance approach, you must also keep in mind that the additive package has been affected. If anyone knows whether or not this is true, please reply. Luckily, water and oil naturally separate. Re: Does Seafoam remove moisture … If you have dirty motor oil with water, take the oil to a recycling center.